The Sensorsoft protocol based Thermometer is a low cost temperature sensor for monitoring temperature of a remote location from your computer. Now you can measure the temperature of buildings, cold storage, warehouses, greenhouses, equipment rooms and laboratory experiments, to name a few, all from the comfort of your computer.
Traditional scale thermometers are often awkward to read, can break and spill toxic fluid and must be read at the location where installed. The Sensorsoft Thermometer however is rugged and can be conveniently read from your computer, regardless of where you locate its sensor.
The Sensorsoft Thermometer connects via cable to an RS-232 serial port on your computer and can be located up to a thousand feet away without the need for a battery or external power adapter. This Sensorsoft device, like all of our sensors, uses our unique Sensorsoft auto discovery protocol that insures a quick and easy installation without set-up or data communication errors.
The ST6105J Sensorsoft Thermometer has an RJ-45 communications jack for modular wiring systems and accepts a variety of modular cables for plugging into terminal/device servers and computers.
Our software (sold separately) provides a convenient way to display your temperature readings in Celsius or Fahrenheit, send alerts and record temperature readings in a file while you're away from your computer.
|Range||-40 ºC to +60 ºC (-40 ºF to +140 ºF) with internal sensor (NIST traceable if ordered with certificate)|
|Precision||0.5 ºC or 0.1 ºC|
|Accuracy||+/- 0.5 ºC over 0 ºC to +70 ºC, +/- 1 ºC over remainder of temperature range|
|Humidity||< 90% RH (non-condensing)|
|Max Measuring Rate||one reading every second|
|Comms Connector||8 position modular jack, (accepts 8 position plug RJ45)|
|Communication Interface||RS232 using TX,RX,RTS,DTR and GND. One device per serial port|
|Max Comms Cable Length||305 m (1000 ft.) using recommended cable type. Low capacitance shielded cable or UTP is recommended. Firmware Version: 5.24|
|Communications Protocol||Sensorsoft Device Protocol (SSDP) Version 2.0|
|Error Control||16 bit CRC (cyclic redundancy checking) for detection of communication errors between this device and host|
|Power Source||Port-powered (RTS and or DTR asserted) or via External DC power connector|
|Power Supply Current Drain||1.5 mA average, 6 mA maximum when port powered (5V RS232)|
|External DC Power Connector||2.1 mm power jack, automatic polarity correction and over-voltage protection|
|External Power Supply Voltage||6.0 - 12.0 VDC|