Sensorsoft Power Failure Sensor

Sensorsoft Power Failure Sensor
Brand: Sensorsoft
Product Code: SS6400J
Price: £120.00
Qty:     - OR -   Add to Wish List
Add to Compare

The Sensorsoft Power Failure sensor is great way to get early detection when your site has a power failure and or is running on a backup power source (UPS battery, diesel generator).

With this product you can be alerted* immediately when power fails or comes back. The SP6400J and mains power adapter form a complete power availability detector that can be used with various software and appliances for email and SMS alerting:
•Sensorsoft Remote Watchman Enterprise (RWME) software
•Sensorsoft .NET component for Developers
•Sensorsoft Alert appliance

Sensorsoft has been manufacturing Power Failure sensor products since 1999.

Datasheet

Performance
Range Operating temperature/humidity range: 0 º C to +60 º C (32 º F to +140 º F) and < 90% RH (non-condensing)
Max Measuring Rate one reading every second
Communication
Comms Connector 8 position modular jack, (accepts 8 position plug RJ45)
Communication Interface RS232 using TX,RX,RTS,DTR and GND. One device per serial port
Max Comms Cable Length 305 m (1000 ft.) using recommended cable type. Low capacitance shielded cable or UTP is recommended. Firmware Version: 5.24
Communications Protocol Sensorsoft Device Protocol (SSDP) Version 2.0 and Version 3.0. For software that supports only Version 2 of the protocol a polling method is used. For software that supports Version 3 of the protocol a real-time method is used.
Error Control 16 bit CRC (cyclic redundancy checking) for detection of communication errors between this device and host
Power
Power Source Port-powered (RTS and or DTR asserted)
Power Supply Current Drain <10mA
External Power Supply Voltage 2.1 mm power jack, accepts plug from AC-DC power adapters such as P/N PA6109 or PA6209. The minimum voltage on this jack must be 7.8 volts DC for a PWR_OK reading. A voltage below this would give a PWR_FAIL reading. The continuous absolute maximum input voltage is 15 Vdc due to transient suppressor. Failure to use the recommended power adapters will void the warranty.
Powered By OpenCart
Waendel Technology Limited © 2018